RESIDENTIAL CLEANING
DUCT CLEANING
Our Duct Cleaning Process
Photo Inspection
STEP ONE
- You can decide if the vent needs to be cleaned before we begin the process
- We will provide our professional opinion, and recommendation. (No pushy sales guy)
Clean the Vent Covers
STEP TWO
- Remove wall, ceiling and Floor registers.
- Clean them thoroughly
Clean Each Vent
STEP THREE
- We send a spinning brush on the end of a powerful vacuum hose down every pipe, scrubbing every piece of ductwork
- Our vacuum process uses a 2 stage HEPA filtered unit so no dust will dift back into your home.
- This is also a closed system, so the heated or air conditioned air stays in your home instead of being sucked out into the driveway
Clean Every Trunk Duct
STEP FOUR
- We create small openings about every 20 feet in your trunk ducts
- We send that same spinning brush system down each run (using a bigger brush)
- We reseal each opening with foil tape and sheet metal screws ensuring a beautiful finished product.
Disinfect the System
STEP FIVE
- We mist the HVAC system with an EPA approved disinfectant treatment
- This kills any harmful microscopic organisms that are in the system (Totally safe for people and pets according to the EPA)
- This also leaves the system smelling minty fresh
Photo Inspection
STEP SIX
- You can see the difference!
- We re-install your cleaned vent grates.
DRYER VENT CLEANING
Our Dryer Vent Cleaning Process
Photo Inspection
STEP ONE
- You can decide if the vent needs to be cleaned before we begin the process
- We will provide our professional opinion, and recommendation. (No pushy sales guy)
Access the pipe
STEP TWO
- Sometimes we will access it from the dryer, and sometimes we access it from the exhaust outlet.
Clean The Pipe
STEP THREE
- We send a spinning brush all the way through to ensure there are no obstructions.
- This includes removing any birds, bees or critters nests that have been built.
Reassemble the System
STEP FOUR
- We put everything back together and move the dryer back in place.
- We also clean the surrounding area of any dust we may have raised.
- To finish, we clean the inside of the lint trap.